corisslide1.png

Nyní jste na stránce:

SEFAB SUPERProducte CORIS®CORIS

Contact us

Coris - Color s.r.o.
Říčanská 1251
763 12 Vizovice

tel./fax: +420 577 452 143
mobil: +420 603 515 053
coris@coris-vizovice.cz



SEFAB® SUPER

Acrylic facade colour

Description

Sefab super is one ingredient, maleable material based on acrylatic dispersion. It is suitable for indoor and outdoor use. Colour shades are available, because of use of foreign made colour – Clariant fast pigments. It has medium granular structure with the size of granules up to 0,35 mm. It stays very firmly attached to a silicate base. It is resistant to rain water (washable). It has very low diffusion resistance. Minimal life of the product is 15 years. Material is environmentally friendly.

Use

Suitable surfaces for the colour are lime-cement and polymer-cement surfaces, plaster materials, transite and cement-chip boards. Firmness of surface must be at least 0,25 Mpa. Dirty surface is best washed by flow of water under pressure.

Preparation of the surface (penetration)

New surface must be dry and carbonized (2 to 3 months). Penetration coating and two coatings with undiluted Sefab super colour are used as surface preparation. Penetration is performed by acrylic adulterated dispersion Sokrat 2802. Dispersions are adulterated at 1 (dispersion) to 3 – 4 (water) ratio. 1 (dispersion) to 2 (water) ratio is used on new, more firm, liquid absorbing surfaces.

Surface coating

The first coat should be applied at the earliest 4 hours after priming using a brush, roll (the surface can be structured), or by spraying. The second coat should be applied at the earliest in 12 hours. The minimum temperature of the air and foundation during work and drying is +5°C.

Storage and transportation

Product is stored and transported in original containers. They are protected from frost, temperature changes, and direct sunlight. Warranty is 24 months if all conditions of transportation and storage are  met. Warranty is valid from the date of production. Product is used undiluted,or not mixed, with the same product of a different shade. It is manufactured in 45 basic shades or in an ordered shade according to a given sample. The product is approved by State Test Room no. 224 ITC Zlin

Packing 5, 15, 25 kg

Basic technical parameters

Adhesiveness to concrete Min. 0,8 Mpa
Adhesiveness to plasterboard 0,2 Mpa
Diffusion Max 0,35 m
Resistance to temperature changes Min. 25 cycles
Wet wear Min. 60 min.
Frost resistance Min 25 cycles
Average consumption 0,5 - 0,6 kg/m2 for 2 coats


Realizace: Enzon